killpg: poslat signál skupině procesů

Originální popis anglicky: killpg - send a signal to a process group

Návod, kniha: POSIX Programmer's Manual

STRUČNĚ

#include <signal.h> int killpg(pid_t pgrp, int sig);

POPIS / INSTRUKCE

The killpg() function shall send the signal specified by sig to the process group specified by pgrp. If pgrp is greater than 1, killpg(pgrp, sig) shall be equivalent to kill(-pgrp, sig). If pgrp is less than or equal to 1, the behavior of killpg() is undefined.

NÁVRATOVÁ HODNOTA

Refer to kill() .

CHYBY / ERRORY

Refer to kill() . The following sections are informative.

PŘÍKLADY POUŽITÍ

None.

APPLICATION USAGE

None.

RATIONALE

None.

FUTURE DIRECTIONS

None.

SOUVISEJÍCÍ

getpgid() , getpid() , kill() , raise() , the Base Definitions volume of IEEE Std 1003.1-2001, <signal.h>

COPYRIGHT

Portions of this text are reprinted and reproduced in electronic form from IEEE Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable Operating System Interface (POSIX), The Open Group Base Specifications Issue 6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics Engineers, Inc and The Open Group. In the event of any discrepancy between this version and the original IEEE and The Open Group Standard, the original IEEE and The Open Group Standard is the referee document. The original Standard can be obtained online at http://www.opengroup.org/unix/online.html .