Originální popis anglicky:
continue - continue for, while, or until loop
Návod, kniha: POSIX Programmer's Manual
continue [n]
The
continue utility shall return to the top of the smallest enclosing
for,
while, or
until loop, or to the top of the
nth enclosing loop, if
n is specified. This involves repeating
the condition list of a
while or
until loop or performing the
next assignment of a
for loop, and re-executing the loop if
appropriate.
The value of
n is a decimal integer greater than or equal to 1. The
default shall be equivalent to
n=1. If
n is greater than the
number of enclosing loops, the outermost enclosing loop shall be used.
None.
See the DESCRIPTION.
Not used.
None.
None.
Default.
Not used.
The standard error shall be used only for diagnostic messages.
None.
None.
- 0
- Successful completion.
- >0
- The n value was not an unsigned decimal integer
greater than or equal to 1.
Default.
The following sections are informative.
None.
for i in *
do
if test -d "$i"
then continue
fi
echo "\"$i\"" is not a directory.
done
None.
None.
Special Built-In Utilities
Portions of this text are reprinted and reproduced in electronic form from IEEE
Std 1003.1, 2003 Edition, Standard for Information Technology -- Portable
Operating System Interface (POSIX), The Open Group Base Specifications Issue
6, Copyright (C) 2001-2003 by the Institute of Electrical and Electronics
Engineers, Inc and The Open Group. In the event of any discrepancy between
this version and the original IEEE and The Open Group Standard, the original
IEEE and The Open Group Standard is the referee document. The original
Standard can be obtained online at http://www.opengroup.org/unix/online.html
.
